16
MAINTENANCE & CARE
Trimmer Body & Hedge Trimmer Attachment
Gear Case
• The reduction gears are lubricated by multi-purpose, lithium-based grease in the gear case. Supply new grease every
20 hours of use or more often depending on job condition.
• Remove the cutter holders before installing new grease to arrange for old grease to exit.
• Screwing in the screw too tightly may make it impossible for the blades to move. Conversely, not screwing in the
screw tightly enough may make the blades of the trimmer feel dull and cause
leaves and branches to become caught in the blades of the trimmer.
• The reduction gears are lubricated by multi-purpose, lithium-based grease
in the gear case. Supply new grease every 20 hours of use or more often
depending on the job condition. (Refer to Fig. 38) for grease points.
Pole Saw Attachment
Gear Case
• When adding lubricant, use a grease gun to insert lubricant into the gear box
(Refer to Fig. 39).
Oiling Port
• Dismount the guide bar and check the oiling port for clogging. (Refer to Fig. 40).
Guide Bar
• Remove sawdust in the bar groove and the oiling port. (Type: Sprocket nose).
(Refer to Fig. 41).
• Grease the nose sprocket from the feeding port on the tip of the bar. (Refer to
Fig. 42). The bar rail should always be a square. Check for wear of the bar rail.
Apply a ruler to the bar and the outside of a cutter. If a gap is observed between them, the rail is normal. Otherwise,
the bar rail is worn. Such a bar needs to be corrected or replaced. (Refer to Fig. 43).
• If the drive rim has wear greater than 0.3 mm the rim should be replaced (Refer to Fig. 44).
Fig. 40
Fig. 41
Fig. 42
Fig. 43
Fig. 44
Fig. 39
Fig. 38
Содержание MULTI-TOOL 36V9701
Страница 1: ...MULTI TOOL 36V9701 OPERATOR S MANUAL ...
Страница 19: ...19 NOTES ...