![background image](http://html.mh-extra.com/html/bushranger/multi-tool-36v9701/multi-tool-36v9701_operators-manual_2835607015.webp)
15
OPERATING INSTRUCTIONS
Switching Off The Multi-tool
Emergency Stop Procedure
• If it becomes necessary to stop the multi-tool immediately. Let go of the
throttle lever. (See Fig. 37).
Feeding Bump Head Line
To increase the length of nylon trimming line when using the Bump Head;
1.
Run the trimmer at maximum RPM while firmly bumping the spool on the ground.
2.
The line will come out incrementally each time head is bumped.
3.
Check the length after each bumping and repeat till the required length is achieved.
4.
Bump and feed the line before it becomes too short and fall back into the bump head. If this happens refer to the
section of “Trimmer Line Assembly – bump head” on page 10.
Note:
refer to “Troubleshooting - Bump head” if the line is not coming out when bumping.
Warning: DO NOT touch the bump head while the engine is running.
DO NOT Bump feed excessive lengths on line longer than the limits of the guards.
Fig. 37
Содержание MULTI-TOOL 36V9701
Страница 1: ...MULTI TOOL 36V9701 OPERATOR S MANUAL ...
Страница 19: ...19 NOTES ...