10
Trimming
This is feeding the trimmer carefully into the
material you wish to cut. Tilt the head slowly to
direct debris away from you. If cutting up to a
barrier such as fence, wall or tree, approach from
an angle where any debris ricocheting off the
barrier will fly away from you. Move the line head
slowly until the grass is cut right up the barrier,
but do not jam (overfeed) the line into the barrier
If trimming up to a wire mesh or chain linked
fence be careful to feed only up to wire. If you
go too far the line will snap off around the wire.
Trimming can be done to cut through weed
stems one at a time. Place the trimmer line head
near the bottom of the weed-never high up which
could cause the weed to chatter and catch the
line. Rather than cutting the weed right through,
just use the very end of the line to wear through
the stem slowly.
WARNING / DANGER
Do not use steel blade on this Bentshaft Trimmer.
Scalping and Edging
Both of these are done with the line head tilted
at a steep angle scalping is removing top growth
leaving the earth bear. Edging is trimming the
grass back where it has spread over a sidewalk or
drive way. During both edging and scalping, hold
the unit at a steep angle and in a position where
the debris, and any dislodging dirt and stones will
not come back towards you even if it ricochets
off the hard surface. Although the picture shows
how to edge and scalp every operator must find
the angles which suit your body size and cutting
situation. (Fig. 11 & 12).
WARNING / DANGER
Do not trim in any area where there are strands or
fencing wire. Wear safety protection. Do not cut
where you cannot see what the cutting device is
cutting.
Fig. 11
Fig.12
Fig. 13
Содержание B2600
Страница 1: ...1 BENT SHAFT TRIMMER B2600 OPERATOR S MANUAL ...
Страница 15: ...15 IPL BENT SHAFT TRIMMER ...
Страница 17: ...17 IPL BENT SHAFT TRIMMER ENGINE ...
Страница 19: ...19 NOTES ...