- 9 -
9.0 TO LIGHT THE HEATER
BEFORE LIGHTING. IF THE PIPES HAVE NOT BEEN PURGED OF DEBRIS, DO SO NOW BEFORE
LIGHTING THE FIRE. FAILURE TO DO SO WILL RESULT IN BLOCKAGES WITHIN THE PILOT.
BURLEY APPLIANCES IS THE ONLY COMPANY TO BENCH RUN AND THOROUGHLY TEST EVERY
SINGLE GAS FIRE IT PRODUCES. BURLEY IS IN THE UNIQUE POSITION OF KNOWING THAT EVERY
APPLIANCE LEAVES THE FACTORY IN PERFECT WORKING ORDER.
MANUAL CONTROLLED HEATERS
9.1
There are 2 control knobs on the appliance. The left hand one (coloured red) controls On /
Off and High / Low flame. The right hand one (coloured black) is the comfort level thermostat
which turns the fire down to pilot only once the desired temperature is reached. Some people
prefer to retain a flame effect using the left hand red knob to control its height whilst keeping the
thermostat black knob set on hot. Others prefer to use the fire purely as a heater in which case
they will select a flame height on the red knob then set the thermostat black knob to a comfort
level. In both cases if the room gets too hot, the thermostat will automatically reduce the fire to
pilot setting until the room cools.
If during use the pilot is alight but the main burner
will not light, check the thermostat position and if
necessary select a warmer setting.
9.2
To light the fire, first ensure the red knob is
turned clockwise to OFF. Press the left hand (red)
control knob for several seconds then turn slowly
anticlockwise to the ignition position. A click will
be heard and the pilot (under right side of fuel
bed) should light. If it does not, repeat the operation a few times to purge any air in the pipe.
Continue to hold knob for 15 – 20 second to establish the pilot and then release. If pilot fails to
establish, turn off, wait 1 minute then repeat lighting procedure. Rotate the red knob to high
flame to light then back to the desired flame position. If no gas comes through rotate the black
knob (thermostat) to a hotter room setting and the fire will light.
9.3
Control the fire by a combination of thermostat and / or flame setting to suit your mode of
use (see 9.1)
9.4
To turn the fire off, rotate the left-hand knob fully clockwise back to a vertical position.
Installation Instructions
NOTE – USE THESE INSTRUCTIONS TOGETHER WITH PUBLISHED DETAILS IN INSTRUCTIONS ABOVE.
If the fire tray is removed for installation, take care to route any fixing cables and gas supply pipes away
from the workings of the burner tray.
Replace the tray and refit the entire coal layout, glass etc in accordance with the Installation Instructions.
