- 8 -
7.0 REASSEMBLY
7.1
To remove the glass, remove the 4 nuts in the side frames and pivoting it out from the
bottom remove glass from its top channel. Refitting is done in reverse order.
7.2 REVERSIBLE SIDE CHEEKS
The appliance has side cheeks that are plain on one side and brick effect on the other. These can
be removed and replaced by the installer to suit the customer’s choice.
7.3
Refit the case before use.
7.4
Remote control fires –
The appliance uses a 7.2 volt rechargeable battery. This is supplied loose with the appliance to
prevent inadvertent operation. To attach to the appliance, plug together the multiblock connector
on the battery with the matching connector on the front right hand side of the fire. Then slide the
battery into position underneath the fire in the purpose made battery housing.
Note – If the fire
emits a beeping sound, this is just the safety system priming itself.
Because the remote control uses battery power, when in the stand-by mode remove from the fire
during long periods of non use. Be sure to brief the user on this as it will extend battery life
considerably. The battery will normally last for 1 month, so demonstrate the way to charge the
battery pack and also explain that the batteries are not covered by warranty.
A handheld remote control is included in the box and this has a 9 volt battery to power it. The
battery should be changed annually to prevent false signalling caused by a partially flat battery.
The battery is accessible through a flip off cover on the back of the handset and the battery
clipped onto the terminals inside.
When disposing of batteries, always do so in an environmentally friendly manner.
Replacement rechargable batteries for the fire and replacement handsets are available from
Burley Appliances on 01572 756956 or through your retailer. The 9 volt handset battery is
available from normal retail outlets.
8.0
PEBBLE / COAL LAYOUT
The base and front pebbles should be
positioned as shown overleaf. The
base locates onto the rear shelf and
sits central and pushed back. The
front pebble moulding is positioned
centrally in its channel with the cut
out on the right as shown. The coal
shapes are similar to pebbles and
fitted in a similar way.
Note the pilot position on the right
hand side of the burner.
It is important for clean burning that
the correct shape is fitted in the correct place. Do not use with incorrectly fitted pebbles.
Always replace the glass after laying the coals. Do not attempt to use the unit with broken /
damaged glass or ceramics. Do not use additional or non standard ceramics.
