secuENTRY
English | 7
2
Carefully pull off the plug.
3
Remove the screw.
Attention! Be careful not to
damage the circuit board or the
cable!
4
Pull the knob from the cylinder and slide the cable from the sleeve.
5
Choose the appropriate adapter for the outside and snap it on. Table 1
provides the required dimensions.
6
Slide the assembly aid on the plug and, together with the cylinder and the
adapter, slide it from inside into the mortise lock.
uaitgzigf
Attention! Do not pinch or
damage the cable!
7
Fix the cylinder using the forend screw.
8
If required, install the cylinder extension (inside/outside) and mark it where
aligned with the fitting. The cylinder extension prevents a stress on the
cylinder.
9
Remove the cylinder extension, use a saw to shorten it to the required
length and mount it back finally.
10
Use the assembly aid to slide the cable through the outer knob.
Attention! Do not pinch or damage the cable!
11
Snap the adapter onto the cylinder.
12
Hold the cable tight and lead it through the nut.
Attention! The cable must not
overlap and must be completely
stowed in the pocket!
13
Use the attached Allen key to fasten the appropriate screw.
Attention! Do not pinch or
damage the cable!
14
Connect the cable with the plate using the plug and stow the remaining
cable in the side pocket intended for this purpose.
15
Inset the battery with the correct polarity and snap on the sleeve.
Please remember: The fixing is possible in just one position!
16
Put the inner knob on the cylinder or on the appropriate adapter and
fasten it with the corresponding screw. Table 1 provides the required
dimensions.
17
Place the sleeve and snap it in.
