secuENTRY
English | 8
Installation instructions for secuENTRY keypad
The keypad is only included in ENTRY Pincode and ENTRY Fingerprint sets.
Attention! Please remember that the keypad should not be attached
to the door itself, otherwise it would transmit shocks when the door
is being shut.
The membrane affixed to the keypad rear side should not be sealed
with glue and/or any other substance under any circumstances!
Exchange of air must also be possible after the installation!
• Determine the installation place for the keypad. For that purpose, enter the
opening code (e.g. PIN code, fingerprint, ...) at the desired mounting place
and check whether the lock opens.
• Place the keypad correspondingly.
You can then decide whether you want to glue the wall holder directly on
the wall or whether you prefer having it screwed on. The slotted holes in the
wall holder provide for an exact alignment.
If you decide for gluing the wall holder, please be sure to provide for clean
surfaces free from fat, oil and silicon films and any other impurities. Remove
completely the protective film from the included adhesive pads, attach all
the pads on the wall holder and then press it firmly to the required position.
When mounting in colder temperatures, please remember that the full
adhesive force cannot be achieved before 72 hours in 20°C, with warmth
accelerating the process (e.g. in 65°C, the full adhesive force will be achieved
in one hour).
When attaching the holder plate on the coloured sight protection film, the
above described conditions relating to cleanliness of surfaces and firmness of
the adhesive pad should be observed.
To provide for a bubble-free application of the colour sight protection film,
please proceed as follows:
• Pour some water with a couple of drops of dishwashing detergent into a
glass,
stir it cautiously free of foam, and then use it to moisture gently the
surface,
on which the film is to be applied.
• Start pulling off the white protective sheet from 1 cm of film and
straighten it out. To change the position, lift this surface carefully and
attach it again as required.
• Then swipe the adhesive film, e.g. with a plastic spatula, out from the
contact surface in the direction of protective sheet still attached.
Attention! Do not use more liquid than absolutely necessary.
• Slide the keypad in from above until the locking
peg of the mounting plate engages into the
keypad housing. In this way, the keypad is
protected against undesired removal.
• Perform a function test of the unit with the door
open. For this purpose, enter repeatedly a valid
opening code (e.g. PIN code, fingerprint, ...).
Battery replacement for secuENTRY keypad
• Remove the housing cover on the bottom side by loosening the 2 screws
(Torx 8).
• Pull the battery compartment lid downwards until it disengages and
replace the batteries.
When inserting the new batteries, be careful to observe the correct
polarity as indicated on the housing.
• To close the battery compartment, first press the battery compartment lid
close to the screw holes to make them slide into the recesses, then snap
the bottom side into position by pressing on it.
• Fasten the battery compartment lid with screws.
Attention! Make sure that no moisture enters the keypad when
replacing the battery.
Cleaning instruction for secuENTRY keypad
The surface finish of the keypad prevents adherence of impurities. Dust or
dirt can be removed from the surfaces using a damp cloth.
No alcohol-
based detergents (spirit, SIDOLIN® etc.) or aggressive detergents
(acetone etc.) may be used, as they can damage the surface or the
sensor.
