secuENTRY
English | 9
Battery replacement for secuENTRY cylinder
• Use the included tool to push the knob latches together and pull the knob
sleeve off.
• Replace the battery while carefully adhering to correct polarity.
• Slide the knob sleeve carefully back to the position.
Please remember: The fixing is possible in just one position!
Attention! Make sure that the
cable is not squeezed. Make sure
that the O-ring sits in the correct
position.
• Let the sleeve snap back into place.
Dismantling of the secuENTRY keypad from
the wall holder
• Remove the housing lid on the bottom side by loosening the 2 screws
(Torx 8).
• Pull the battery compartment lid downwards until it disengages.
• Press the latch using a narrow tool (e.g. flat-bladed screwdriver)
downwards and slide the keypad upwards.
Interference with Bluetooth devices
Bluetooth devices use the same frequency band (2.4GHz) as WiFi devices.
This can cause interference leading to errors or even to communication
failure. In such case, any devices not required should be kept disconnected
from power.
Warranty
In order to be able to provide you with perfectly flawless and high quality
products and an optimal support when you need servicing or repair, we
need you to present faulty or defective devices to your vendor together with
a valid administrator code and the QR code(s), with the original purchase
document attached.
When you return a device component based on your right of withdrawal
from the purchase agreement, such component must be adjusted to factory
settings and the seal on the cylinder and on the knob must be intact. In case
of noncompliance with this, the warranty becomes invalid.
Disposal of the device
Dear customer,
Please help us avoid unnecessary waste. Should you ever intend to dispose of
this device, please bear in mind that many components of the device contain
precious materials, which can be recycled.
Please be aware that electrical and electronic equipment
and batteries shall not be disposed of as household waste,
but rather collected separately. Please obtain information on
the collecting points for electrical waste from the
responsible authority of you municipality.
If you have any questions concerning the EC declaration of
conformity, please use [email protected]
Errors and changes reserved.
