19
11. Repeat step 10 until the top line is complete.
12. Select
DONE
. The display should now read
WRITE
BTM LINE?
.
13. To write the bottom line, select
YES.
14. To skip the bottom line, select
NO
.
a. If neither a top nor bottom line was written, the
display should now read
ENABL SANITATION
.
b. If only a top line was written, the ad will be
displayed followed by
SAVE?
Proceed to step 18.
15. The display will now read
A
with a flashing cursor
below it. Scroll through the alphabet and available
characters. When the desired character is shown
on the display, select
NEXT
to move to the next
character in the bottom line.
16. Repeat step 15 until the bottom line is complete.
17. Select
DONE
. The display will now show the written
ad, and then
SAVE?
18. To cancel saving the ad, select
NO
. The display
should now read
ADVERTISEMENT NOT SAVED!
and then will return to the
NEW AD
screen.
19. To correct or edit the ad, select
EDIT
. The display
should now read
WRITE TOP LINE?
Repeat steps
10 though 17.
20. To save the ad as it is shown, select
YES
. The
display should now read
ADVERTISEMENT SETUP
COMPLETE
, and then
ENABL SANITATION
. To exit
programming and return to the
MAIN SCREEN
,
press
ENABLE BREW ON/OFF
switch.
Procedure to READ in a new Ad:
NOTE:
Saving a new ad will erase any previously saved
ad in the brewer’s memory.
7. From the
NEW AD?
screen, select
CARD
.
8. The display will show
INSERT AD CARD
. Place
the AD CARD vertically so that the top end of the
"chip" is beneath the sensing coil (located on the
underneath side of the front display panel).
9. After a short pause, the display will read
CARD
CONTAINS AD
. To view the ad, press and release
SHOW
. To save the ad to the brewer's memory,
select
SAVE
. To cancel, select
QUIT
.
10. After the ad is saved, the display will read
AD
MESSAGE SETUP COMPLETE
.
PROGRAMMING FUNCTIONS (cont.)
PROGRAMMING BREWER
(cont.)
(cont.)
