9
PROGRAMMING WITH AD CARD
Using an AD CARD to load ADS:
The information is loaded into the brewer’s memory by
holding the chip area up to the brewer’s
SENSING COIL
.
NOTE:
Instructions to program the brewer are printed
on the
AD CARD
.
Procedure to program the AD:
1. Remove the funnel(s) if present.
2. Position the
RECIPE CARD
vertically, so that the
top end of the
CHIP
is beneath the (Left on Twins)
SENSING COIL
(located on the underneath side of
the front display panel).
3. After a short pause the display will read
CARD
CONTAIN ADS/SHOW-QUIT-SAVE
.
4. To show (view) this information, select
"SHOW"
.
The display will scroll through all of the ad on that
chip. The display will then return to
CARD CONTAIN
ADS/SHOW-QUIT-SAVE
.
5. If message is correct, press
SAVE
. The display will
read
AD MESSSAGE SETUP COMPLETE
. The ad is
now stored in the brewer’s memory.
6. If the ad is not correct, or it is desired to exit the
setup before the ad is loaded into the brewer’s
memory, press
QUIT
. The display will then return
to the
MAIN SCREEN
.
POSITION CARD UNDER
SENSOR COIL
SCROLLS THROUGH
COMPLETE MESSAGE
NOTE: ENABLE ADS
must be
turned on in order for the newly
programmed ad message to be
displayed.
READY TO BREW
CARD CONTAIN ADS
AD MESSAGE
READY TO BREW
WATER TEMP XXX°
SHOW QUIT SAVE
SETUP COMPLETE
WATER TEMP 200°
BREW
A
BREW
B
BREW
C
BREW
A
BREW
B
BREW
C
EN
ABLE
BREW
I O
EN
ABLE
BREW
I O
To reduce the risk of electric shoc
k,
do not remo
ve or open co
ver
.
No user
-ser
viceab
le par
ts inside
.
Authoriz
ed ser
vice per
sonnel onl
y.
Disconnect po
wer bef
ore ser
vicing.
WA
RN
ING
