17
SET NEW RECIPE (COFFEE ONLY)
To set a new COFFEE recipe using a Smart Funnel
and a G9-2T DBC or MHG Grinder:
This function allows the operator to set
BREW VOL-
UMES, BYPASS %, PULSE BREW/PREINFUSION
TIMES AND DRIP OUT TIMES
for each coffee name
stored in the grinder’s memory.
Certain coffee names are stored in the grinder’s memory.
When a particular name of coffee is ground into the
Smart Funnel, that name and the batch size selected
are transferred from the grinder to the programming
CHIP
located in the funnel handle. The funnel is then
inserted into the brewer’s funnel rails. The
SENSING
COIL
on the brewer reads the information contained in
the handle. The name of the coffee flavor will then ap-
pear on the display. This allows the operator to set the
BREW VOLUMES, BYPASS % (N/A on ITCB), PULSE
BREW/PREINFUSION TIMES AND DRIP OUT TIMES
for that particular coffee name. Each coffee name can
be set individually to provide optimum brewing quality.
3. On the brewer, press and hold the right hidden
switch until the display reads
RECIPE
, then press
SELECT.
Press and release the right hidden switch
until the display reads
SET NEW RECIPE
.
4. Select
YES
. The display should read
INSERT FUN-
NEL WITH NEW NAME
, then
QUIT SETUP?
These
two displays will repeatedly cycle.
5. Insert the funnel into the rails on the brewer (Left
on Twins). The display should read the name of
the coffee that was ground into the funnel, along
with a
NO
and
YES
. If the name on the display is
correct, press
YES.
6. If, for some reason, the name of the coffee from
the grinder did not load properly into the funnel,
or if a grind has not yet been done, the display will
read
MUST GRIND INTO FUNNEL FIRST
. It will be
necessary to grind another batch following steps
1, 2 & 5.
NOTE:
If brewer memory is full, the display will read
RECIPE STORAGE AREA IS FULL
and then
REMOVE A
FLAVOR?
To remove a recipe press and release
YES
.
Press
NEXT
to scroll through the stored recipes. When
the display reads the name of the recipe to be removed,
press and release
REMOVE
. The display will read
RE-
MOVE?
Press
CANCEL
to exit the
SET NEW RECIPE
function. Press
OK
to remove that recipe. The display
will then show
BEGIN SETUP OF (COFFEE NAME)
.
7. If the grind is acknowledged by the brewer, the
display will read
BEGIN SETUP OF (COFFEE NAME)
.
Then the screen will display
BREW OZ
and a batch
light will be blinking. Follow steps on page 11
(
Review Recipes
) to adjust recipe settings.
Procedure for Setting the Recipe:
NOTE
: Before beginning setup, place a server beneath
the brew funnel.
1. Insert the funnel into the grinder and select the
small batch size to grind. It is not necessary to have
coffee beans in the hopper(s) in order to program
the brewer. The coffee name is pre-selected and
stored in the grinder’s memory for the side being
ground.
2. Press the
GRIND
switch. When the grinder stops
grinding, remove the funnel.
Brew Ounces
% Bypass
Dilution Delay Time
Pulse Brew/Preinfusion Times
Drip Times
SET NEW COFFEE ITEMS
ICB SH/ICB TWIN SH
PROGRAMMING FUNCTIONS
(cont.)
PROGRAMMING BREWER
(cont.)
(cont.)
