ccd_manual_e
Page 20 /36
Press
OK
. The machine now moves to the tool sensor, checks the test tool and places it in slot num -
ber 0. Then the spindle moves back to the sensor to check whether the tool was correctly dropped.
After that it continues to slot number 1 to load the first tool. The length of tool 1 is checked at the
sensor, the spindle starts and a positioning and drilling movement is performed. After that the ma -
chine checks if the tool is not broken and sets the tool again in slot 1. This cycle is repeated until all
14 (XL 25 ) tools are checked. Please be prepared to either press the
ESCAPE
key ( = emergency
stop ) on your keyboard or click on the red
X
in the top left in the RoutePro3000 window to directly
stop the machine in case the tools were not picked properly or a collision is about to happen. This
may happen in case of a transport damage or if you drive the machine with incorrect parameters.
Make sure that the LEDs of the limit switches and the tool sensor go on and off again when the ma -
chine reaches the corresponding positions.
After the last tool, the spindle picks again the test tool and moves to the machine zero point.
All CCDs: Make a first drill and routing at-
tempt!
To do so load the project file
ccd_PCB_quickstart.xml. You will find this
file on your C-drive at: C:\Program Files
(x86)\RoutePro3000\Projects. This is a
single sided board with 3 different drills, a
simple isolation and a cut-out-routing.
Fix a standard drill backing board using the
provided clamps on the machine table. Now fix a
PCB with at least 160 x 100 mm dimension
about 5 mm off the machine zero point (in this
project the offset for X and Y is set to 10 mm,
we recommend first to use this setting when you
create a new project. Always compare the thick-
ness of your backing board and your PCB with
the values shown in the software !!!l!)
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]