ccd_manual_e
Page 19 /36
(ATC) tool slots
At the front of the machine there is a bar with 16 tool slots, numbered
from 0 to 15 (XL: 26 pots). Number 0 always takes up the test pin, the
routers and drills are located in the remaining round aluminum slots.
Each tool can be moved up and down in the slot and is urged upwards
by a spring. The position of the slots is stored to the software via
entries in the configuration menu.
The drill break sensor is located to the left of tool slot 0. The operating
software checks each drill for breakage after use. This sensor is also
used to detect too long tools and sort them out so that they can not
cause any damage.
Tool change MTC + CCD/2)
To open the chuck, press the button at the top of the spindle until it
locks and turn it to the left. Repeat this until you can remove the tool from the chuck. For better
access, you can lift the spindle, but it is not recommended to lift it completely out of the holder.
Tool change during the program execution is carried out with energized motors. The current
position of the axes is thus locked.
ATC:
Check the function of the tool
changer. Go to tab
General
and click
on
Open
to load the project file
ccd_PCB_-15tools. (XL-Version: -25
Tools). This project file is located after
a normal installation at C:\Program Files (x86)\RoutePro3000\Projects\ccd_PCB_15-tools
Go to tab
Run CNC
and click on the tri-
angle
START
. The next dialogue asks
you to place the tool to the correspond-
ing tool slots. Make sure that the tools
have a length of 38 mm and the distance
between the top of the ring to the tool tip
is 21 mm. Furthermore, a test tool must
be in the spindle and the tool slot 0 must
be empty. Check the correct fitting of the
tools in the slots. Since there are toler-
ances in the ring diameters, it can be ne-
cessary to adjust the slots. You can eas-
ily widen them with a screwdriver and
tighten them by pressing from outside
against the lamellae.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]