ccd_manual_e
Page 13 /36
Existing machines younger than 2016 (CCD3000)
For an update, it may be necessary to update the firmware. For
machines older than 2016 (Atmel versions), this happens
automatically. For machines younger than 2016 (CCD3000-Alvidi),
the controller must be updated manually . When you start the update
for RoutePro3000, the warning message appears that the firmware is
not up-to-date. In this case, open the UpgradeFW.exe file. This is
usually found at: C: \ Program Files (x86) \ RoutePro3000 \ Firmware
Upgrade. Follow the instructions of the software. Then you can start RoutePro3000 normally.
Existing machines with RoutePro2008
The SetupRoutePro3000.exe file is located on the CD. All necessary files including the machine and tool parameters
are in this setup. The documents, licenses, and projects folders are also stored on the CD, so that you can, for example,
read the help before the installation, or have access to the licenses without installing RoutePro3000. After installation,
you have to transfer the specific machine parameters of your machine (correction factors, table, sensor and tool
positions) from RoutePro2008. Alternatively, you can change your old machine configuration (routepro.rpc) via the
OPTIONS - MACHINE – (tooth wheel) - IMPORT RPC
If you have a new machine the CD coming with the machine is already adapted to your specific machine. No further ac -
tion beyond registration and activating licenses need to be done. Still we recommend to compare the machine paramet -
ers at
options
–
machine
with the PDF print out coming with the machine.
If you update from RoutePro2008 to Route Pro3000, you need to
establish the correct parameters for your machine. Process like
this: Start RoutePro3000 and go to options and machine. Hoover
over the CCD-picture and insert correct parameters for XYZ-mo-
tors, spindle, tool slots, sensor and table. You can copy the values
from your RoutePro.ini-file of your older Software RoutePro2008.
Alternatively you can print screenshots from your RoutePro2008
software and copy the values from the screenshots.
Please note:
there is one exception concerning the Z-position of
the tool slots. In RoutePro2008 the z-position of the tool slots was
0.5 – 1 mm less than z-max. E.g. if z-max was
37.65
, then z-posi-
tion of the tool slots was approx. 37.00mm. In RoutePro3000 the
table is the
0-Position
of the
z-axis
and you almost put the tool to
0. So now you have to insert 0.5 – 1.0 mm in the ATC-
tool position table.
Attention: Back up your RoutePro3000 version regularly
and also the associated licenses. If you want to change
the computer or re-install the operating system: First,
deactivate the licenses!
Only after successful deactivation the licenses are
available on the new computer!
For more details on installing and using RoutePro3000,
see the RoutePro3000 Help. Now you can use the RoutePro3000 software with your CCD.
The current RoutePro3000 version is available at:
http://www.bungard.de/downloads/software/UpdateRoutePro3000.zip
Have fun with your CCD and the new software Routero3000!
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]