Bullard LANCER, Инструкция по эксплуатации

Страница: 13 / 26

Before you can size the headband,
the cape and suspension must be
removed from the helmet using the
following steps:
1. Open hinged window frame by lift-
ing up on window latch.
2. Remove cape from helmet by lifting
up on over-center clamp and disen-
gaging cape from helmet groove.
3. Turn helmet upside down and
remove suspension by pulling up
on hanger keys until they pop out
of the helmet.
4. Size the 88TG suspension by
squeezing top and bottom edges of
rear buckle together with your thumb
and forefinger (see Figure 4). At
the same time, decrease suspen-
sion size by sliding right hand por-
tion of suspension through buckle.
Do not release buckle.
5. Place the headband on your head.
Pull down allowing suspension to
expand until it feels comfortable.
Suspension automatically adjusts to
your size and locks when you
release your grip (Figure 5).
6. Remove suspension from your head.
The suspension may be raised or low-
ered in the front and/or back by repo-
sitioning the hanger keys. Vertical
adjustment makes the suspension
ride higher or lower on wearer’s head.
It also can adjust the tilt forward or
backward.
1. Rotate hanger key 90° in either
direction until hole in hanger key
aligns with post on suspension.
Pull key away from suspension
(Figure 6).
2. Move key to desired vertical
position.
3. Rotate hanger key 90° toward sus-
pension until key locks in place
(see Figure 6).
4. Repeat steps 2-4 for other suspen-
sion keys.
1. Turn helmet and suspension upside
down.
2. Place suspension inside helmet with
brow pad facing front of helmet.
3. Bending hanger keys outward at
hinge, insert keys into respective
key slots. Push firmly until keys
snap into place (see Figure 7).
R E S P I R ATOR AS S E M B LY
BEFORE ASSEMBLING THIS RESPIRATOR, READ THE WARNING LABELS
ON THE INSIDE OF THE RESPIRATOR CAPE AND THE HELMET SHELL.
REMOVE AND READ THE WARNING CARD INSERTED BETWEEN THE
RESPIRATOR’S TWO LENSES.
Sizing the Headband
Figure 5
Figure 6
Figure 7
Figure 4
11
Adjusting Suspension
for Vertical Fit
Installing Suspension
into Helmet