1. Place cape on table or workbench
(see Figure 8).
2. With window frame open, place
helmet on top of cape.
3. Line up the hook-shaped clip on
the cape with the front center of the
helmet (see Figure 8).
4. Firmly engage clip under bottom
front edge of helmet.
NOTE: Installation is easiest when
started at the front of cape and hel-
met.
5. Ease cape rim completely into the
groove along helmet edge, working
your way to the back. Be certain
cape is completely in place at every
point along helmet’s bottom edge.
6. Snap the over-center clamp to
tighten cable and hold cape snugly
on helmet.
7. Close and latch window frame.
1. Remove nylon clamp from the open
end of the breathing tube. Do not
remove foam from inside the
breathing tube. The foam helps
reduce the noise level and turbu-
lence of the incoming air.
2. Insert the breathing tube approxi-
mately five inches into the air deliv-
ery system’s air entry sleeve (see
Figure 9).
3. Install nylon clamp over air entry
sleeve and breathing tube, inserting
clamp locks through two holes in
plastic anchorplate sewn into the
air delivery system. Locks should
face away from user’s neck (see
Figure 10).
4. Engage clamp locks and squeeze
together until tight.
5. Gently tug on breathing tube to
ensure that it is properly engaged
to the air delivery system.
Attaching Cape to Helmet
Figure 8
Figure 9
Figure 10
12
Installing Breathing Tu b e
Assembly into Air Delive r y
S y s t e m
Helmet
Window frame
Hook-shaped
catch
Table or workbench
Cape
Over-center clamp
Top rim of cape
Window latch
Helmet grove
Rear of helmet
Cape cable
