INSPECTION: Remove the suspen-
sion from the helmet. Inspect suspen-
sion system for cracks, frayed or cut
crown straps, torn headband or size
adjustment slots, loss of pliability or
other signs of excessive wear.
If damage is detected, replace parts
immediately with Bullard replacement
parts or remove the respirator from
service.
CLEANING: The suspension should
be hand-sponged with warm water
and mild detergent, rinsed and air-
dried. After cleaning and before
reassembling, once again carefully
inspect the parts for signs of damage.
INSPECTION: Inspect the helmet for
nicks, gouges, cracks, holes and any
damage due to impact, rough treat-
ment or wear. Check areas around all
rivets for signs of stress cracking.
If damage is detected, replace parts
immediately with Bullard replacement
parts or remove the respirator from
service.
CLEANING: The helmet and window
frame should be hand-sponged with
warm water and mild detergent,
rinsed and air-dried.
After cleaning and before reassem-
bling, once again carefully inspect the
helmet and parts for signs of damage.
INSPECTION: Be sure the plastic
inner lens fits securely in the black
window frame gasket. Remove any
grit or dust from the gasket. Be sure
the plastic outer lens is installed
underneath the clamps on the back o f
the outer window frame. It should be
positioned within the one upper and
two lower positioning points. Inspect
the window frame gasket closely for
cuts, wear or damage that will prevent
a proper seal against the inner
faceshield lens or the helmet window
frame.
CLEANING: To clean the lenses,
hand-sponge with warm water and
mild detergent, rinse and air-dry.
WA R N I N G
:
DO NOT USE
LENSES OTHER THAN THOSE
LISTED ON THIS PAGE. USE OF NON-
BULLARD LENSES MAY ALLOW
CONTAMINANTS TO ENTER THE
RESPIRATOR AND EXPOSE YOU TO
LIFE THREATENING CONDITIONS,
DISEASES OR DEATH.
NOTE: All Bullard lenses are stamped
with the appropriate Bullard part num-
ber described below.
Bullard Lens
Bullard Lens
Description
Part No.
Inner lens for
LANCER
™
respirators .................... 771B
Outer lenses for
respirators .......................... 771 or 771R
Suspension System
Lenses and Window Fra m e
G a s ke t
H e l m e t
17
Headband Suspension
Helmet
Plastic Inner Lens
Window Frame Gasket