Bull Escala PL 1650R-L+, Информация о оборудовании

Страница: 61 / 90

Place the service access cover A on the top of the system unit, approximately 25 mm (1 in.) from the
front of the system unit, as shown in the following figure. 2.
Hold the service access cover against the system unit, and slide it toward the front of the system.
Ensure that the fan LED cables do not get caught on the front edge of the service access cover as
you move it forward.
The tabs on the service access cover slide beneath the upper chassis ledge, and the thumbscrew
aligns with the screw hole at the back of the system unit.
3.
Tighten the thumbscrew B located at the back of the cover.
Figure 1. Install the service access cover on the rack-mounted model ESCALA PL 250R-VL or
ESCALA PL 450R-XS
4.
Close the service access panel C and ensure the tabs D lock into place. 5.
Parent topic: Open the model ESCALA PL 250R-VL or ESCALA PL 450R-XS service access panel
Place the model ESCALA PL 250R-VL or ESCALA PL 450R-XS in the
service position
If you are servicing the fans or control panel see: Open the model ESCALA PL 250R-VL or ESCALA PL
450R-XS service access panel .
Important: To place the model ESCALA PL 250R-VL or ESCALA PL 450R-XS in the service position you will
need to remove the system unit from the rack.
Note: Some of the figures in these procedures might not look exactly like the system unit that you have.
However, the steps to perform the task are the same.
DANGERWhen working on or around the system, observe the following precautions:
Electrical voltage and current from power, telephone, and communication cables are hazardous. To avoid a
shock hazard:
Control panel
Install the service access cover on the rack-mounted model ESCALAPL 250R-VL or ESCALA PL 450R-XS 55