Bull Escala PL 1650R-L+, Информация о оборудовании

Страница: 36 / 90

The product might be equipped with multiple power cords. To remove all hazardous voltages,
disconnect all power cords. •
Connect all power cords to a properly wired and grounded electrical outlet. Ensure that the outlet
supplies proper voltage and phase rotation according to the system rating plate. •
Connect any equipment that will be attached to this product to properly wired outlets. •
When possible, use one hand only to connect or disconnect signal cables. •
Never turn on any equipment when there is evidence of fire, water, or structural damage. •
Disconnect the attached power cords, telecommunications systems, networks, and modems before
you open the device covers, unless instructed otherwise in the installation and configuration
procedures. •
Connect and disconnect cables as described in the following procedures when installing, moving, or
opening covers on this product or attached devices.
To Disconnect:
Turn off everything (unless instructed otherwise). 1.
Remove the power cords from the outlets. 2.
Remove the signal cables from the connectors. 3.
Remove all cables from the devices 4.
To Connect:
Turn off everything (unless instructed otherwise). 1.
Attach all cables to the devices. 2.
Attach the signal cables to the connectors. 3.
Attach the power cords to the outlets. 4.
Turn on the devices. 5.
(D005)
•
DANGERObserve the following precautions when working on or around your IT rack
system:
Heavy equipment personal injury or equipment damage might result if mishandled. •
Always lower the leveling pads on the rack cabinet. •
Always install stabilizer brackets on the rack cabinet. •
To avoid hazardous conditions due to uneven mechanical loading, always install the heaviest devices
in the bottom of the rack cabinet. Always install servers and optional devices starting from the bottom
of the rack cabinet. •
Rack-mounted devices are not to be used as shelves or work spaces. Do not place objects on top of
rack-mounted devices. •
Each rack cabinet might have more than one power cord. Be sure to disconnect all power cords in the
rack cabinet when directed to disconnect power during servicing. •
Connect all devices installed in a rack cabinet to power devices installed in the same rack cabinet. Do
not plug a power cord from a device installed in one rack cabinet into a power device installed in a
different rack cabinet. •
An electrical outlet that is not correctly wired could place hazardous voltage on the metal parts of the
system or the devices that attach to the system. It is the responsibility of the customer to ensure that
the outlet is correctly wired and grounded to prevent an electrical shock. •
CAUTION
Do not install a unit in a rack where the internal rack ambient temperatures will exceed the
manufacturer's recommended ambient temperature for all your rack-mounted devices. •
Do not install a unit in a rack where the air flow is compromised. Ensure that air flow is not blocked or
reduced on any side, front, or back of a unit used for air flow through the unit. •
Consideration should be given to the connection of the equipment to the supply circuit so that
overloading of the circuits does not compromise the supply wiring or overcurrent protection. To
provide the correct power connection to a rack, refer to the rating labels located on the equipment in
the rack to determine the total power requirement of the supply circuit. •
(For sliding drawers.) Do not pull out or install any drawer or feature if the rack stabilizer brackets are
not attached to the rack. Do not pull out more than one drawer at a time. The rack might become
•
Control panel
30 Before you begin