Buell 2003XB9S, Руководство по обслуживанию

Страница: 217 / 588

3-14 2003 Buell XB9S: Engine
HOME
REASSEMBLY
NOTE
● If exhaust header was removed during service it must be
torqued with the engine rotated in the down position. It is
not possible to reach fasteners on the rear exhaust at the
head with engine rotated in the up position.
● Tighten header nuts gradually, alternating between studs
to insure that exhaust rings are flush with engine. Tighten
fasteners to 72-96 in-lbs (8.1-10.8 Nm).
1. When repairs have been completed, rotate engine back
up into frame.
NOTE
When installing and tightening front isolator bolt it is important
to keep load off of isolator bolt for installation purposes. Alter-
nate between tightening front isolator bolt and raising engine
with scissors jack.
NOTE
See Figure 3-9. Always coat shaft and threads of front isola-
tor bolt with anti-seize before installing.
2. See Figure 3-10. Insert front isolator bolt (1) through
front isolator (2) and loosely thread into frame. Do not
tighten at this point.
3. See Figure 3-10. Install isolator mounting fasteners (3)
and tighten to 49-51 ft-lbs (66.4-69.1 Nm).
4. Tighten front isolator bolt to 49-51 ft-lbs (66.4-69.1 Nm).
5. See Figure 3-6. Torque rear isolator bolt to 49-51 ft-lbs
(66.4-69.1 Nm).
6. See Figure 3-6. Install rear tie bar to frame and tighten to
25-27 ft-lbs (33.9-36.6 Nm).
7. See Figure 3-6. Install center tie bar to engine and
tighten to 25-27 ft-lbs (33.9-36.6 Nm).
8. See Figure 3-6. Install front “V” bracket with oil cooler to
main frame.
a. Install “V” bracket to main frame from the left side of
the vehicle and tighten to 120-144 in-lbs (13.6-16.3
Nm).
b. Figure 3-10. Install front tie-bar to “V” bracket and
tighten to 25-27 ft-lbs (33.9-36.6 Nm).
c. Attach regulator wiring harness to bracket nylon
cable straps.
9. Remove scissors jack.
Figure 3-9. Lubrication Points on Front Isolator Bolt
b1041x2x
Figure 3-10. Front Isolator and Tie Bar Assemblies
1. Front isolator bolt
2. Front isolator mount
3. Front isolator mount fasteners (2)
4. Front tie bar
4
2
1
3
8720