Buell 2003XB9S, Руководство по обслуживанию

Страница: 199 / 588

2-96 2003 Buell XB9S: Chassis
HOME
SIDESTAND ASSEMBLY 2.43
SIDESTAND
Removal
1. Remove muffler. See Muffler and Straps in 2.29
EXHAUST SYSTEM .
2. See Figure 2-118. Remove sidestand switch (6). See
SIDESTAND SWITCH in this section.
3. Remove fasteners (2) securing sidestand bracket (3) to
frame.
4. Remove sidestand.
Installation
1. Install sidestand to frame tightening the sidestand
bracket fasteners to 25-27 ft-lbs (34-37 Nm).
2. Install sidestand switch to sidestand assembly.
3. Install muffler. See Muffler and Straps in 2.29 EXHAUST
SYSTEM .
4. Inspect sidestand. See INSPECTION in this section.
SIDESTAND SWITCH
Removal
1. See Figure 2-116. Cut cable strap securing harness.
2. Remove shrink tubing covering connector [60] and
unplug.
3. See Figure 2-117. Remove sidestand switch (2).
a. Retract sidestand leg (6).
b. Remove switch fastener (1).
c. Extend sidestand leg (6).
4. Lift sidestand switch (2) and slide to the right away from
spring post (4) on sidestand bracket (5).
Installation
5. Install sidestand switch (2).
a. Extend sidestand leg (6).
b. Install sidestand switch (2) by aligning the lug on the
bottom side of the switch with the corresponding
hole in the sidestand leg (6).
c. Install the switch fastener (1) tightening to 36-60 in-
lbs (4-7 Nm).
Figure 2-116. Sidestand Switch with Cable Strap
Figure 2-117. Sidestand Switch
8712
1. Switch fastener
2. Sidestand switch
3. Sidestand pivot bolt
4. Spring post
5. Sidestand bracket
6. Sidestand leg
8712
1
2
5
6
3
2
1
4