Buderus Logatop BE 1.3, Инструкция по установке и обслуживанию, Страница: 16 / 56

Initial burner start-up 6
Buderus Blue Flame Burner BE 1.3 - 2.3 - Specifications subject to change without notice. 16
6.4 Bleeding oil line
The oil supply system must be checked to ensure that
the burner will operate properly (see Chapter 9 „Layout
of oil supply system“, page 36). Check the suction resis-
tance and inspect for leaks, particularly in retrofit sys-
tems.
There are two methods for bleeding the oil line:
– Oil suction pump – this will prevent damage to the oil
pump caused by running dry.
– Burner tester (Fig. 11, Item 1 ; Accessory) – if the
burner oil pump is to supply the oil.
The procedure for bleeding the oil line with the burner
tester (Fig. 11,
Item 1 ) is described below.
z
Disconnect the heating system from the electric pow-
er.
z
Remove automated burner controller (Fig. 10,
Item 2 ) from its base.
z Plug burner tester (Fig. 11, Item 1 ) into the base.
z
Switch ON power to the heating system.
z Switch on control mode switch. The LED (red) lights
(Fig. 11,
Item 2 ).
z Switch on burner tester with the mode switch
(Fig. 11,
Item 5 ) . Both LEDs (red and green) light
(Fig. 11, Item 2 and 3 ).
z
Switch on oil preheater (Fig. 11, Item 4 ) switch.
z
Check that the oil in the Tigerloop reservoir (Fig. 10,
Item 4 ) is free from bubbles.
Fig. 10 Oil filter, vacuum meter and transparent hose
Item 1: Oil suction line
Item 2: Automated burner controller
Item 3: Vacuum meter
Item 4: Tigerloop
Item 5: Oil return line
1
2
3
4
5
Fig. 11 Bleeding oil line with burner tester
Item 1: Burner tester
Item 2: LED (red)
Item 3: LED (green)
Item 4: Switch for running the oil preheater
Item 5: Burner tester switch
63044451-03.1K
3
2
4
1
5
CAUTION!
SYSTEM DAMAGE
from a defective oil pump.
z
Never run the pump without oil longer
than five minutes.