Operating the Logamatic BC10 base controller
9
Logano GB125 oil condensing boiler - Technical specifications are subject to change without prior notice.
49
9.10 Adjusting parameters
Operating the parameter mode
9.10.1 Limiting the heating load
We recommend you keep the factory setting.
9.10.2 Pump run-on time
This parameter determines the run-on time of the boiler pump in minutes.
This parameter can be recognised by the letter "F". The setting "F1d" means the
boiler pump runs constantly.
9.10.3 DHW
This parameter determines whether DHW is to be heated by this boiler. This pa-
rameter can be recognised by the letter "C". At setting 0, even frost protection is
deactivated.
Hold down the "Flue gas test" and "Status display" keys simultaneously for
5 seconds to call up the parameter setting mode.
Press the "Status display" key to change to the next parameter.
Press the "Reset" button to reduce the value of the relevant parameter (-).
Press the "Flue gas test" key to increase the value of the relevant parameter (+).
The system exits the parameter mode if no key has been pressed for 5 minutes.
+
F5
Input range
Factory setting
Pump run-on time F
1 - 60 min
24 h ("F1d")
5 min
This setting is appropriate
for room temperature-de-
pendent control.
C0
Input range
DHW C
0 (no DHW)
1 (DHW)
Содержание Logano GB125
Страница 65: ...Notes Logano GB125 oil condensing boiler Technical specifications are subject to change without prior notice 65...
Страница 66: ...Notes Logano GB125 oil condensing boiler Technical specifications are subject to change without prior notice 66...
Страница 67: ...Notes Logano GB125 oil condensing boiler Technical specifications are subject to change without prior notice 67...
