Bucktool BD4603, Инструкция по эксплуатации

Страница: 17 / 24

OPERATING DUST EXHAUST
Sanding operations are inherently dusty. It is strongly recommended that users
attach a shop vacuum when using this belt/disc sander. Use of a mask or respirator
is still recommended even when a dust-collection system is in use.
NOTE: Do not operate the sander without first turning on the shop vacuum.
REPLACING SANDING DISC
REPLACING SANDING BELT
A sanding disc is pre-mounted at the factory. Use only sanding discs that
measures 6 in. (150 mm) in diameter.
1. Remove the disc worktable and then
remove the disc cover (1) by removing
four screws (2).
2. Remove the existing disc, and clean any
residue left on disc plate (3). Only use
mineral spirits to remove this residue.
3. Peel the plastic (4) back from new
sanding disc (5) and carefully press
sanding disc firmly in position around
the sanding plate. Make sure the disc is
centered on the plate.
4. Reinstall the disc cover (1), tighten four
screws (2) and place sanding table back
on unit.
1. Remove the belt worktable.
2. Position the belt work support frame horizontally as shown. Loosen the inner
hex screw (1) by using a 5 mm hex wrench, turning it counterclockwise. Do
not remove the screw.
3. Remove the two screws (2, 3) by using a phillips screwdriver, and pull out the
tension lever (4) to release the tension of the sanding belt (5). Remove the belt
exhaust cover (6).
4. Remove the sanding belt (5) from both sanding drums (7).
5. Place new sanding belt over sanding drums. Make sure the belt arrow located
on the inside of the belt is pointed in the right direction.
6. Replace the belt exhaust cover (6) in position.
16
BD4603
MAINTEN
ANCE
1
2
3
5
4