12
The belt backstop prevents the workpiece from being pulled or dragged beyond
the sanding belt surface. It should always be used to help control the workpiece
when using the sanding belt.
1. Loosen the inner hex screw (1) using the
5 mm hex key, and raise the belt bed (2)
in the 90 degree vertical position. Tighten
the inner hex screw (1). (Fig. C)
2. Place the fence (3) onto the sander
frame, aligning the slot (4) on the fence
with the threaded hole (5).
3. Insert two screws (6) through the slot (4)
and tighten into threaded hole (5) with the
5 mm hex key.
The use of a dust collection system with the sander is strongly recommended.
It will maintain shop cleanliness, and help prevent possible health hazards
caused by wood dust.
The sander has two dust ports. Slide the hose of your dust collector over the
outlet, and secure with a hose clamp.
NOTE:
Dryer vent hoses are not acceptable for this purpose.
A miter gauge (1) is supplied with your sander and can be used with the sanding
table. The miter gauge body can be adjusted from 0° to 60° right or left for angle
or miter sanding.
1. Install the miter gauge bar (2) into the
table slot (3) as shown.
2. Loosen lock knob (4) and then rotate
miter gauge body to the desired angle.
3. Tighten lock knob (4).
INSTALLING BELT BACKSTOP
INSTALLING DUST COLLECTION
MITER GAUGE
BD4603
OPERA
TING INSTR
UCTIONS
3
4
5
6
1
4
3
2
Содержание BD4603
Страница 2: ......
Страница 20: ...BD4603 19 EXPLODED VIEW...