Bucktool BD4603, Инструкция по эксплуатации

Страница: 15 / 24

14
TO PROPERLY TRACK THE SANDING BELT
LEVELING THE SANDING BELT
ON/OFF SWITCH
1. Plug in the sander.
2. Turn power switch ON, then immediately
OFF, noting whether the belt (1) tends to
slide off its track, and to which side (front
or back) of the sander.
3. If the sanding belt does not slide to either
side, it is tracking properly.
4. Viewed from the switch end, if the sanding
belt runs toward the disc side, slightly turn
the tracking knob (2) clockwise (down).
5. Viewed from the switch end, if the
sanding belt runs away from the disc
side, slightly turn the tracking knob (2)
counterclockwise (up).
6. Turn power switch ON, then immediately
OFF again, again taking note of any belt
movement.
7. Readjust tracking knob (2) another 1/4
turn, necessary.
The support rod is designed for adjusting the level of sanding belt. To adjust,
please do the following.
1. Loosen the lock nut (1) on the upper end
of the support rod (2) with the adjustable
wrench.
2. Adjust the support rod (2) upward or
downward to leveling the sanding belt (3).
3. When the level of the sanding belt (3) is
achieved, tighten the lock nut (1).
The ON/OFF power switch is located on the front of the sander, and
incorporates a removable safety key.
In situations where the sander may be left unattended, the operator has the
option of removing the “black” safety key of the ON/OFF switch to render the
sander inoperable. When the operator is ready to use the machine again,
simply insert the "black" safety key into the slot in the switch and pushing it in
until it "seats."
BD4603
OPERA
TING INSTR
UCTIONS
up
down
1
2
1
2
3