Step 3-
Once assembled, place the Back Pad on your waist. To ensure proper fit:
1: Connect two halves of Quick Connect Waist Buckle for proper securement.
Visually inspect that buckle is secured. Do not rely on only hearing the click.
Look for both sides to be locked.
2: Pull on straps as shown until waist strap feels snug on waist.
Be sure not to
over tighten as this can cause discomfort on hips and waist.
Step 4
Once the waist straps are secured and
properly tensioned, they can be threaded
back through the slot of the work
positioning “D” ring and secured in the
waist strap keepers.
WARNING:
NEVER CUT WAIST STRAP ENDS.
Leg Strap Assembly
Step 1
Lay out leg pads (G) with the longer narrow side going to the inside of the
thigh.
Step 2
Slide the leg strap under the web loops at each end of the leg pad
and place the loop fastener side of the leg strap (D) down securely
matching up with the hook fastener side of the leg pad
(G).
Note:
Be sure to orient leg pad (G) with long narrow portion going
towards inside of thigh.
If you would like your leg strap buckle on the
OUTSIDE
of your
thigh, set up as shown in attachment
#1.
If you would like your leg strap buckle on the
INSIDE
of your thigh,
set up as shown in attachment
#2.
Step 3
Thread the leg strap through the male end of the Quick Connect Buckle Frame as
follows:
Insert slide bar (F) over the Quick Connect Buckle Frame (E).
Push the slide bar to the rear of the frame creating a slot at the tab end of frame.
Ensure the foldover of the leg strap is facing up. Insert the leg strap from the
underside of the buckle and through the slot.
Push the slide bar to the tab end of the frame, make a loop
in the leg strap and insert it through the slot at the rear of the frame.
Pull the tail of the leg strap to cinch the buckle tight to the strap.
Ergovation.Doc 11-3-08 (Rev. 8-18-17)
PN 230216
