(Omega) Suspension Bridge Replacement / Assembly Instructions
Assembled View (Front)
Note: The Omega Suspension Bridge is supplied from the manufacturer with the
minimum required tail length labels shown in step 5. These labels are not shown
throughout this document for clarity purposes. To tie the termination knots in the
Omega Suspension Bridge, follow the steps below.
Step 1-
Wrap the working end towards the long side of the rope.
Step 2-
Wrap the working end twice to form a round turn
around the standing part of rope.
Step 3-
Insert the working end back through the two crossed round turns.
Step 4-
Once the termination knot is tied, dress and set the knot.
Step 5-
Pull the knot tight until all slack is removed from the two turns.
WARNING:
THREE INCHES MINIMUM OF
TAIL IS REQUIRED EXITING
THE TERMINATION KNOT.
Step 6 -
Insert the terminated and tied portion of the rope into the climbing plate center hole.
Insert or attach appropriate hardware onto the rope.
Repeat steps 1 – 5 for opposite side.
Ergovation.Doc 11-3-08 (Rev. 8-18-17)
PN 230216
