btsr IS3W/MTC, Руководство по эксплуатации

Страница: 64 / 89

Operation
- 3.50 - SMART 200 MTC
LOAD - Loading an article to sensor memory
WORK LOAD
This function allows you to load an article (more specifically the settings of the
article) on a specified range of sensors connected to the SMART 200 MTC system.
The sensors must have been previously declared and numbered using the CONFIG
DEVICE function.
Press to have access to the function.
Press once or several times until the name of the required article you wish to
load into the sensor appears.
At this point press . This screen indicates the first and last device (sensor) on
which you wish to load the article.
XXX and YYY represent the range of sensors on which you want to load the
selected article, in particular:
XXX shows the first sensor
YYY shows the last sensor
Increases the number where the cursor is positioned.
Decreases the number where the cursor is positioned.
Moves the cursor between XXX and YYY fields.
Press and hold down for 3 seconds to switch from Side A to Side B and vice
versa (if the SIDE option is enabled) .
Press to confirm the setting and go to the next screen.
Press to load the parameters of the article in the selected range of sensors.
During the loading phase the message OK WAIT LOAD is shown for a few
seconds.
If you try to load an article into a range of sensors to which another article was
previously loaded, the system signals the incompatibility by displaying the ERR
DEV OVERLAP message.
In this case it is necessary to unload the previous article, using the UNLOAD
function and repeat the LOAD function, to load the new article.
In case of a programming error, the system signals the fault with the message ERR
DEV
nnn , where nnn is the number of sensor which has not been programmed
correctly.
Press once to return to the POS DEV screen and continue with programming
a new set of sensors.
Press twice to return to the XXX LOAD screen and select a new article to load.
Press three times to return to the Main Menu.
F