BTL – 07p
operating manual & user's guide
page 7
Starting the combined therapy
Set the instruments after they are connected. Set all needed parameters on the BTL 07p and press the
START/PAUSE button (17). Press the STOP button (V/mA) (18) to set the voltage (the V control light is on).
Choose the program and set the therapy time. Apply the electrode and the emitter head to the treatment area.
The moment the emitter head touches the skin, the ultrasound will start and the time will begin to count down.
Press the button (19) on the electrotherapy unit to set the voltage and start the combined therapy. Caution: Keep
the ultrasound emitter head on the treated area during the therapy!
Ending the combined therapy
After the pre-set time has elapsed and the START/PAUSE button (17) on the BTL-07p has been pressed, the
combined therapy stops. If there is a need to stop or interrupt the application before the pre-set time elapses,
press the button (18) on the BTL-06 before removing the emitter head or the electrode from the skin.
Summary of directions for use
1.
Connect the instrument to the mains.
2.
Switch the instrument to "1".
3.
Connect an emitter head to the instrument.
4. Choose the required program.
5. Check if the READY control light is flashing. If it is not, the emitter head is probably not connected.
6. Press the START/PAUSE push-button (17) to start application.
7. Press the START/PAUSE push-button (17) to interrupt therapy.
8. Therapy ends automatically when the pre-set time has elapsed.
Safety instructions
The BTL-07p ultrasonic therapy instrument is constructed with maximum regard for the safety of the patient and
therapist. However, it is absolutely essential to strictly follow the safety instructions below:
1.
Read the operation manual carefully before you use the instrument for the first time.
2.
Make sure that the parameters of the mains correspond to those of the instrument.
3.
The mains must be installed and correspond to valid norms. Call a qualified electrician if in doubt.
4.
If the instrument is exposed to a sudden temperature charge, allow at least 1 hour for the temperature of the
instrument to equalize before turning it on.
5.
Stop the therapy immediately if the instrument shows any signs of malfunction. If the instrument does not
turn on when activated, call or fax BTL’s Service Department. Do not attempt to repair the instrument!
Removing the instrument housing will invalidate the service warranty.
6.
Do not touch the metallic parts of the emitter head during therapy.
7.
Make sure that all set parameters correspond to the desired parameters.
8.
Do not cover the vents. Do not place the instrument on a soft surface that would prevent air from circulating
beneath it.
9.
Never use the connectors for anything else but the electrotherapeutic instrument and the emitter head.
The user should not use the instrument, if it does not work as described in this manual. Contact your BTL service
technician. The user is responsible for all damages resulting from using such an instrument.
All materials that come in contact with the patient (gel, emitter head cleaners, etc.) comply with ISO 10993-1,
ISO 10993-3 and ISO 10993-5 standards on hypersensitivity, toxicity and carcinogenicity.
The user is responsible for use of all materials and parts not supplied by BTL.
WARNING!
!
These symbols mean that the electric voltage and current flowing through the input
may exceed safe
levels. BTL-07p has a BF safety level and floating attached parts. Never use the instrument in a manner other
than that described in this operation manual!