BT Redcare Secure Mk3, Инструкция по установке, техническому обслуживанию и эксплуатации

Страница: 33 / 44

July 2013 © British Telecommunications plc 2013
Page 31

Phone number 2. Default = 08009173265. Telephone number of B side ESP servers.

Username. Default = BT Redcare@btinternet.com. Username for dialup RAS

Password. Password for dial up RAS.

Voltage fail delay. Default = 120s. Delay time before loss of PSTN voltage is reported.
(Pin 955 alarm). Also delay time before GPOP1 operates for loss of PSTN voltage.

Voltage restore delay. Default = 30s. Delay time before restore of PSTN voltage is
reported. (Pin 955 restore). Also delay time before GPOP1 restores for restoration of
PSTN voltage.
Panel settings

Ultra alarm format = Contact ID. Events generated by the secure unit are sent to ARC
in this format. (Note: dial capture events are sent as they arrive from panel)

Kiss Off /Ack window. Default = 0 ms. Allows the dial capture kiss off time to be
extended. (0 - 2000 ms). i.e. HKC panels may require 1850ms.

Off line timeout. Default = 1500 minutes. Unit will reboot if no polls are received from
ESP over any path for this period of time. (1500mins = 25 hours)

Mains Fail time. Default = 7 minutes. Time delay before pin 13 alarm is reported.

Low DC fail time. Default = 1 minute. Time delay before Low supply voltage alarm is
reported. (pin 985 alarm)
General Purpose input sense settings.
Tick for positive applied triggering. Untick for positive removed triggering.

Inputs 1-8 (Default all ticked, pos applied)

Inputs 9-16 (Default all ticked, pos applied)
Line Fault Debounce time.

Wireline. Default = 2 mins. Time before GPOP1 will operate following IP path
failure.

Wireless. Default = 15 mins. Time before GPOP1 will operate following GPRS path
failure.

Dial IP. Default = 15 mins. Time before GPOP1 will operate following PSTN path
failure.
(Note: GPOP1 will restore immediately following path restoral).