BT Redcare Secure Mk3, Инструкция по установке, техническому обслуживанию и эксплуатации

Страница: 23 / 44

July 2013 © British Telecommunications plc 2013
Page 21
Example – to configure pin 4 to be positive removed:-

Access the button config menu by holding M for 3 seconds.

Repeatedly Press M until P1 is displayed.

Press S – the display now shows pin 1 and its current polarity.

Repeatedly press M until pin 4 is shown with its current polarity.

Repeatedly press S until the required pin 4 polarity is shown.

Repeatedly press M to scroll through the rest of the pins and then to the ?? (save
changes question marks)

Press S and the ?? will flash to prompt “Are you sure?”

Press S and the unit will briefly display Pr (program) as the changes are written to
flash. The unit will then restart.
At any time the configuration mode can be exited, without saving changes, by holding down M
for 5 seconds.
Ethernet mode - Static / DHCP (F1).
The function 1 (F1) button menu allows the unit to be changed between dynamic (DHCP
client) or Static mode.
When F1 is set to 0 (default) then the Ethernet port will attempt to obtain an IP address from a
DHCP server on the LAN.
When F1 is set to 1 then the Ethernet port can be configured with a static address by using the
F2 / F3 and F4 menu functions.
Example - To change the Ethernet mode:

Access the button config menu by holding M for 3 seconds.

Repeatedly Press M until F1 is displayed.

Press Set – the display now shows the current mode. i.e. =0 for DHCP, or =1 for Static.

Press S to toggle the value to the required setting.

Press M to return to the F1 main menu.

Repeatedly press M to scroll to the ?? (save changes question marks)

Press S and the ?? will flash to prompt “Are you sure?”

Press S and the unit will briefly display Pr (program) as the changes are written to
flash. The unit will then restart.
At any time the configuration mode can be exited, without saving changes, by holding down M
for 5 seconds.
Setting a static IP Address, Netmask and Gateway Address (F2 F3 and F4)
It the secure unit is to be connected to a LAN that requires the unit to have a static IP address
(i.e. no DHCP server on the LAN) then this can be configured as follows.