Brute MagnaTech BMGH1600, Инструкция по установке и эксплуатации, Страница: 84 / 116

Page 80 B
RADFORD
W
HITE
94 Header sensor fault H 1. Check wiring and correct any possible
errors.
2. Replace the header sensor.
3. If previous steps are correct and fault
persists, replace the module.
95 Stack sensor fault H 1. Check wiring and correct any possible
errors.
2. Replace the stack sensor.
3. If previous steps are correct and fault
persists, replace the module.
96 Outdoor sensor fault H 1. Check wiring and correct any possible
errors.
2. Replace the outdoor sensor.
3. If previous steps are correct and fault
persists, replace the module.
Code Description Procedure
97 Internal Fault: A2D mismatch. L Internal Fault.
1. Reset module.
2. If fault repeats, replace module.
98 Internal Fault: Exceeded VSNSR
voltage tolerance
L Internal Fault.
1. Reset module.
2. If fault repeats, replace module.
99 Internal Fault: Exceeded 28V
voltage tolerance
L Internal Fault.
1. Reset module.
2. If fault repeats, replace module.
100 Pressure Sensor Fault H 1. Verify the Pressure Sensor is a 4-20 ma
source.
2. Check wiring and correct any possible
errors.
3. Test Pressure Sensor for correct operation.
4. Replace the Pressure sensor.
5. If previous steps are correct and fault
persists, replace the module.
105 Flame detected out of sequence H or L 1. Check that flame is not present in the
combustion chamber. Correct any errors.
2. Make sure that the flame detector is wired
to the correct terminal.
3. Make sure the F & G wires are protected
from stray noise pickup.
4. Reset and sequence the module, if code
reappears, replace the flame detector.
5. Reset and sequence the module, if code
reappears, replace the module.