Brute MagnaTech BMGH1600, Инструкция по установке и эксплуатации

Страница: 53 / 116

Page 49
MagnaTech
BOILERS AND VOLUME WATER HEATERS
• At the end of the verification process, you
must press the Reset button on the front of the
controller. See Figure 29. You have to do this
within 30 seconds, or the verification will be
cancelled. To make it easy to reach the Reset
button, open the door on the front of the boiler and
slide out the control panel before beginning the
verification.
Figure 29. Reset Button on Controller
4. The system will present a listing for each
group of parameters that need verification
See Menu 7.
Menu 7. Safety Parameter Confirmation
5. For each group, check the list carefully.
Press Yes if all of the parameters in the
group have been entered correctly. For
each group, you are given 30 seconds to
select Yes/No.
A count-down timer is shown at the bottom
of the screen.
If you made changes in other safety-
related groups, verify the entries in those
groups in the same way. Do this until the
following screen shows
Menu 8. Safety Parameter Reset
6. When the process is complete, the system
will
tell you to reset the control system. The
Reset button is located on the front of
the controller. You must press the
Reset button within 30 seconds, or the
verification will be cancelled. A count-
down timer is shown at the bottom of the
screen.
9.4 Checking Individual Parameters
1. From the ‘home’ screen (Menu 9), press
the icon for the controller.