Brush Bandit 65A, Инструкция по эксплуатации и каталог запасных частей

Страница: 48 / 72

Bandit
PRINTED 4/02 PAGE 34
MODELS 65A & 65AW MAINTENANCE SECTION
MONTHLY MAINTENANCE
1) Check hydraulic pressures on the feedwheel
system:
Check, reset and maintain hydraulic feedwheel
pressure setting to a maximum of 1500 P.S.I. This
provides the best performance from the hydraulic feed
system.
2) Check feedwheel teeth for sharpness:
Replace if needed.
3) Check towing hitch:
Check for excessive damage or wear. Replace if
needed. Keep greased to reduce wear.
4) Hydraulic oil filter:
Must be replaced after FIRST 10 HOURS OF
OPERATION, USE AE-10 MICRON FILTER. After
first change replace oil filter every 3 months or 400
hours. Change hydraulic suction screen quarterly or
every 400 hours.
BOLT TORQUE CHART
(THESE TORQUES ARE BASED ON DRY, CLEAN THREADS)
DESCRIPTION BOLT SIZE FT./LBS. TORQUE
Chipper Bearing Bolts (Belt Side) 5/8” - 11 NC 150
Chipper Bearing Bolts (Infeed Side) 1/2” - 13 NC 70
Chipper Shaft Bearing Retainer 5/8” - 11 NC 150
Feed Plate Anvil 1/2” - 13 NC 65-75
Feedwheel Bearing Set Screws 5/16” - 24 NF 165 INCH/LBS.
Engine Hold Downs 3/8” - 16 NC 35
Engine Hold Downs 1/2” - 13 NC 60
Wheel Lug Nuts 1/2” - 20 NF 90
Knife Bolts 1/2” - 13 NC 70-80
Feedwheel Hydraulic Motor Nut 3/4” - Nut 150-170
Before tightening bolts be sure you have the correct size bolt for the correct amount of torque. Knife Bolts
Must Be Premium Quality, Grade 8 Hardness!
5) Tire air pressure:
Fill tires to rated tire capacity.
6) Check discharge, and infeed hopper wear:
Check for wear on discharge, infeed hopper, and
discharge direction adjustor, build up, repair or replace
as needed.
7) Inspect tapered feedwheel motor connections.
Check and maintain correct torque, on feedwheel
motor connections.
8) Check bearing lock collars:
Check, retighten all bearing lock collars to correct
torques.
KEEP LUG NUTS PROPERLY TIGHTENED, CHECK NEW UNIT BEFORE OPERATION, CHECK AGAIN
AFTER 20-25 MILES AND REGULARLY CHECK AT LEAST WEEKLY.
5 & 6 Lug Hubs (1/2” - 20 Studs) ................................................ 90 - 120 ft./lb. Torque
8 Lug Hubs (1/2” - 20 Studs) ...................................................... 90 - 120 ft./lb. Torque
8 Lug Hubs (9/16” - 18 Studs) .................................................... 110 - 120 ft./lb. Torque
8 Lug Hubs (5/8” - 18 Studs) ...................................................... 175 - 225 ft./lb. Torque
10 Lug Hubs (3/4” - 16 Studs) .................................................... 450 - 500 ft./lb. Torque
(Torques per axle manufacturer specifications)