Brush Bandit 65A, Инструкция по эксплуатации и каталог запасных частей

Страница: 41 / 72

Bandit
PRINTED 4/02 PAGE 27
MODELS 65A & 65AW START-UP PROCEDURES
BEFORE STARTING ENGINE,
cont.
15) Check and/or adjust belt tension on chipper belt
drives.
16) Check hydraulic pump and motor shaft for fit
and tightness.
17) Inspect all fuel lines and hydraulic hoses, and
hydraulic fittings for damage or leaks. Replace
if necessary.
18) Check hydraulic oil level, this should always be
7/8 full. Remember to check DAILY to avoid
excessive heat build up.
19) Check the fuel level, check the fuel lines, fuel tank,
and fittings for fuel leaks. (Running out and
repriming is time consuming.)
20) Check engine oil and coolant levels, make sure
they are at the proper level for operation.
21) Inspect / replace axle dust caps, or grease axles
per axle MFG. manual. Inspect and adjust brakes
as needed per axle MFG. manual.
22) Check clutch for proper engagement tension and
lubrication, frequently adjust and grease, per PTO
manufacturers manual recommendations.
23) Make sure discharge direction is pointed safely.
24) Block tires and tongue for stability before
operation.
25) Maintain and service the “Last Chance Stop”
system so it is always operational if needed.
26) Remember to check EVERYTHING on the
checklist.
USE CORRECT KNIFE HARDWARE
NOTICE
DO NOT use a size or style
chipper knife, bolt or nut other than factory
approved for this chipper - see manual.
DO NOT over torque or under torque knife
bolts and nuts - see manual.
DO NOT resharpen knife more than minimum
width - see manual.
DO NOT use a knife bolt or nut which has
been tightened over (5) times - replace.
DO NOT improperly install the knife
nuts. Flat surface of nut goes toward
the chipper disc.