5. OPERATION
25
KE-434C,435C
5-4. Operating the emergency stop switch
If the emergency stop switch is pressed while normal sewing or test sewing is being carried out, the sewing machine will
immediately stop operating.
Canceling an emergency stop
1. Turn the emergency stop switch (1) clockwise and then
pull it out to release the lock.
2. Press the RESET switch (2) on the control panel.
* The electronic alarm will stop sounding.
3. If not joining a new thread, press the RESET switch (2)
once more so that the display panel flashes. Turn the
pulley by hand to set the needle to the needle up stop
position, and then continue with sewing.
Continuing sewing from a stopping point
If the emergency stop switch was pressed because a thread
breakage occurred or the lower thread ran out, sewing can
be resumed from the point where the thread ended.
1. Turn the emergency stop switch (1) clockwise and then
pull it out to release the lock.
2. Press the RESET switch (2) on the control panel.
* The electronic alarm will stop sounding.
3. Press the BOBBIN. WIND switch (3) to trim the thread.
4. Press the BOBBIN. WIND switch (3) once more.
* The work clamp will move backward one stitch at a
time while this switch is being pressed. If the work
clamp moves back too far, press the TEST switch (4) to
move the work clamp forward. Press the TEST switch
(4) once more when you would like the work clamp to
stop.
5. Once the work clamp has returned to the desired
position, depress the foot switch. The sewing machine
will then resume sewing.
5-5. Operating the thread wiper switch (KE-435C)
The thread wiper can be turned on and off using the thread
wiper switch (1).
2608Q
2604Q
2605Q
2606Q
2607Q
0093Q
