Brother DCP 8060, Руководство по обслуживанию

Страница: 318 / 495

8-23 Confidential
8.4.13 Paper Feeding and Ejecting Test (Function code 67)
Function
This function allows you to check that a sheet of paper is fed and ejected correctly by
printing the grid pattern on a page, whose interval is 1cm.
Operating Procedure
(1) Press the [6] and [7] keys in this order in the initial stage of the maintenance mode.
The “SELECT: TRAY1” will appear on the LCD. Press the [OK] key.
The “PAPER FEED TEST” will appear on the LCD.
The test printing is started, and the grid pattern is printed.
(2) To return the machine to the initial stage of the maintenance mode, press the
[Stop/Exit] key.
NOTE: In the case that the front cover is opened, or that there is no paper in the tray
during test printing, the test printing is stopped.
8.4.14 EEPROM Customizing (Function code 74)
Function
This function allows you to customize the EEPROM according to language, function
settings, and firmware switch settings. The customizing codes list is given in Appendix 3.
NOTE: If you replace the main PCB, be sure to carry out this procedure.
Operating Procedure
(1) Press the [7] and [4] keys in this order in the initial stage of the maintenance mode.
The current customizing code (e.g., 0002 in the case of DCP-8060 Canada model)
appears.
(2) Enter the desired customizing code (e.g., 0001 in the case of DCP-8060 U.S.A. model).
The newly entered code appears.
To enter letters “A” through “F”, press the [1] through [6] keys while holding down the
[#] key respectively.
NOTE: The machine does not work properly when an incorrect code is entered.
(3) Press the [Start] key.
The machine saves the setting and appears the “PARAMETER INIT” on the LCD.
The machine returns to the initial stage of the maintenance mode.
If you press the
[Stop/Exit] key or no keys are pressed for one minute in the above
procedure, the machine stops the procedure and returns to the initial stage of the
maintenance mode.