Brother BAS H series, Инструкция по эксплуатации

Страница: 53 / 141

CHAPTER 3 PROGRAMMING PATTERNS
BAS H series, Programmer
45
Changing the attributes of sewing points
1.
Touch
.
2.
Touch
.
3. Touch to set the skipping units (1, 10, 50,
100, 500, 1000, 5000) and code display switching
(Hide code, Show code).
■ Selecting continuous sewing points for editing
4. Touch to set the selection method to
"Range select".
5. Use to move the cursor to the start point
for the range that you would like to select.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
6. Press .
7. Use to move the cursor to the end point
of the range that you would like to select. The
sewing points will change to red, and the points from
the start point to the end point will be selected.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
8. Touch to set the attribute (Stitch, Feed,
Baste).
9. Press .
■
Manually selecting component points for
editing
4. Touch to set the selection method to
"Manual select".
5. Use to move the cursor to the sewing
point that you would like to move.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
6. When you press the key once, the sewing point
will change to red and it will be selected.
When you press the
key once, the selected
sewing point will be unselected.
7. If there is more than one attribute that you would
like to change, repeat steps 5 and 6.
*
To select all outlines
Hold down to select all sewing points in an
outline.
* To unselect all outlines
Hold down to unselect all selected sewing
points.
8. Touch to set the attribute (Stitch, Feed,
Baste).
9. Press .
* When switching from "Feed" to "Stitch" or from "Baste" to
"Stitch", the sewing pitch must be 12.7 mm or less (for the
BAS-360H, BAS-365H, BAS-370H and BAS-375H, 20.0
mm or less) for both X and Y. If the setting is outside the
range, the buzzer will sound twice and processing will stop.
Attributes
Skipping units
Code display
switching
Selection method