Brother BAS H series, Инструкция по эксплуатации

Страница: 46 / 141

CHAPTER 3 PROGRAMMING PATTERNS
38
BAS H series, Programmer
E
E
d
d
i
i
t
t
i
i
n
n
g
g
p
p
r
r
o
o
g
g
r
r
a
a
m
m
s
s
(
(
E
E
d
d
i
i
t
t
i
i
n
n
g
g
o
o
u
u
t
t
l
l
i
i
n
n
e
e
c
c
o
o
m
m
p
p
o
o
n
n
e
e
n
n
t
t
p
p
o
o
i
i
n
n
t
t
s
s
)
)
This section describes the icons which are used when editing outline component points and how to use them.
* You cannot edit the outline component points for outlines which have been loaded from *.SEW files.
Deleting an outline component point
1.
Touch
.
2.
Touch
.
3. Touch to set the selection method.
■
Selecting continuous component points for
editing
4. Touch to set the selection method to "Range
select".
5. Use to move the cursor to the start point
for the range that you would like to select.
*
You can move the cursor continuously by holding down
the key.
6. Press .
7. Use to move the cursor to the end point
of the range that you would like to select. The
component points will change to red, and the points
from the start point to the end point will be selected.
*
You can move the cursor continuously by holding down
the key.
8. Press .
■
Manually selecting component points for
editing
4. Touch to set the selection method to
"Manual select".
5. Use to move the cursor to the component
point that you would like to delete.
* You can move the cursor continuously by holding down
the key.
6. When you press the
key once, the component
point will change to red and it will be selected.
When you press the key once, the selected
component point will be unselected.
7. If there is more than one component point that you
would like to delete, repeat steps 5 and 6.
* To select all outlines
Hold down to select all component points in
an outline.
* To unselect all outlines
Hold down to unselect all selected component
points.
8. Press .
Selection method
Selection method
Selection method