Brother 888-G30, Руководство по эксплуатации

Страница: 92 / 124

Embroidering
90
■
Changing the thread color display
You can display the name of the thread colors or
embroidery thread number.
a
Press and use or to display the following
settings screen.
b
Use or of the menu to select [Name of
Color] or [#123] (thread number).
• When [Name of Color] is selected, the name of the
thread colors is displayed.
• When [#123] is selected, the embroidery thread
number is displayed. Use or of the
menu to select the thread brand.
c
Press .
■
If the bobbin runs out of thread
When the bobbin begins to run out of thread during
embroidering, the machine will stop and the message
below will appear. Press
and follow the directions
below to replace the bobbin. If very little sewing remains,
you can embroider approximately 10 final stitches without
rethreading the machine by pressing
. The machine
will stop after sewing approximately 10 stitches.
a
Press .

After the thread is automatically cut, the carriage will
move.
b
Unlock the frame-securing lever and remove the
embroidery frame.
• Be careful not to apply strong force to the fabric at
this time. Otherwise, the fabric may loosen in the
frame.
c
Insert a wound bobbin into the machine. (Refer to
“Installing the bobbin” on page 22.)
d
Attach the embroidery frame.
e
Press .
f
Press .
g
To return to the area in the pattern where you stopped
sewing, follow steps
c
through
f
in the next
section.
Memo
• Colors on the screen may vary slightly from actual
spool colors.
• [Original], imported data remains the brand thread
created with the software, is set as a default.