Brother 888-G30, Руководство по эксплуатации

Страница: 25 / 124

Winding/Installing the Bobbin
GE
T
T
IN
G RE
A
D
Y
23
1
e
Slide the bobbin cover latch to the right and remove
the bobbin cover.
f
Insert the bobbin into the bobbin case so that the
thread unwinds to the left.
g
Lightly hold down the bobbin with your right hand
(
1 ), and then guide the end of the thread around the
tab of the needle plate cover with your left hand (
2
).
h
While lightly holding down the bobbin with your right
hand (
1
), guide the thread through the slit in the
needle plate cover ( 2 ) and lightly pull it with your left
hand (
3
).
i
While lightly holding down the bobbin with your right
hand (
1
), continue guiding the thread through the slit
with your left hand (
2
). Then, cut the thread with the
cutter (
3
).
j
Reattach the bobbin cover.
Insert the tab of the bobbin cover into the notch of the
needle plate cover, and then lightly press down on the
right side.
k
Press to unlock all keys and buttons.
Memo
• For the correct winding direction of the bobbin
thread, be sure to place the bobbin into the bobbin
case in the same orientation that it was on the
bobbin winder shaft.
The “b” mark on one side of the bobbin included
with this machine can be used as a reference.
1
Tab
CAUTION
• Be sure to hold down the bobbin with your
finger and unwind the bobbin thread
correctly, otherwise the thread may break or
the thread tension will be incorrect.
Memo
• By guiding the thread around the tab of the needle
plate cover, passing the thread as shown by
2
in
this illustration, then lightly pulling the thread at
3
,
the thread will enter the tension spring of the
bobbin case to apply the appropriate tension to the
bobbin thread during sewing.
Memo
• Be sure to complete the bobbin threading correctly
according to these instructions. If the thread is
simply placed in the slit in the needle plate cover,
the bobbin thread will not be correctly threaded,
resulting in poor sewing performance or incorrect
thread tension.
Memo
• You can begin sewing without pulling up the
bobbin thread. If you wish to pull up the bobbin
thread before starting to sew, pull up the thread
according to the procedure in “Pulling up the
bobbin thread” on page 26.