15
Item
Fig.
Explanation
25
9/10
Battery pack
26
9
Charge level display
27
9
LED button
28
9
Integrated lock
29
9/11
Charging socket
30
10
Mounting rail
Assembly
[Fig. 10] Inserting/removing the battery pack
The Brose e-Bike System can be combined with a large
number of different battery pack variants. Fitting and
removal of the battery pack (26) depend on the battery
pack model used. Detailed information on this can be
obtained from your bicycle dealer and the bicycle ma-
nufacturer.
N.B.: Always switch off the battery pack (26) before in-
serting it into the mounting (31) or removing it from the
latter.
Locking/unlocking the battery pack key
The different assembly variants of the battery pack (26)
also entail different variants of the battery pack key (29).
Detailed information on locking/unlocking the battery
pack (26) can be obtained from your bicycle dealer and
the bicycle manufacturer.
Putting into service
Testing the battery pack before its first use
The battery pack (26) is supplied partially charged. For
that reason, test the battery pack (26) before charging it
for the first time or using it with your e-Bike.
−
Press the LED button (28) to switch on the battery
pack (26).
→
The charge level display (27) should now light up
between “empty” and “full” and then display the
current charge level for about 4 seconds.
→
If no LED in the charge level display (27) comes on
and the battery pack (26) cannot be activated, it
may be that the cell voltage is too low and the
battery pack (26) needs to be charged.
→
If at least one but not all LEDs of the charge level
display (27) comes on, the battery pack (26) should
be fully charged before it is first used.
[Fig. 11] Charging the battery pack
Use only the battery charger (33) supplied with your e-
Bike. Only this charger is matched to the lithium-ion
battery pack (26) used in your e-Bike.
N.B.: The battery pack (26) is supplied partially charged
(approx. 30-50 %). To ensure full power from the battery
pack (26), fully charge it before its first use using the
battery charger (33) (see also „Battery charger“ on
page 18).
The battery pack (26) can be charged at any time, either
separately or on the e-Bike, without shortening its ser-
vice life.
−
Connect the battery charger (33) to the mains.
→
The LED status display (34) of the battery char-
ger (33) should now be active (see „LED status
displays“ on page 19).
Battery pack not on e-Bike:
−
Connect the charging plug (32) of the battery char-
ger (33) to the charging socket (30) of the battery
pack (26).
→
The charging operation begins.
N.B.: Some battery packs (26) can be provided with two
charging sockets (30). It is not important which of the
two sockets (30) you use for charging.
Battery pack on e-Bike:
−
Connect the charging plug (32) of the battery char-
ger (33) to the vacant charging socket (30) of the
battery pack (26).
→
The charging operation begins.
N.B.: Interrupting the charging operation does not da-
mage the battery pack (26).
N.B.: If the battery pack (26) does not recharge, then the
cell voltage has fallen below the critical value of 2 V per
cell and the battery pack (26) is defective.
N.B.: Do not charge a damaged battery pack (26) and do
not use it. Please contact an authorized bicycle dealer.
N.B.: The battery pack (26) attains its maximum service
life when it is charged at ambient temperatures between
10 and 30 °C.
Charge level display
The five LEDs of the charge level display (27) show the
charge level of the battery pack (26) when the LED
