10
Safety directions
−
Please follow all safety directions and instructions
found in both these Instructions for Use and in all
other sets of instructions supplied with the e-Bike.
→
Not following these safety directions and instruc-
tions can lead to electric shocks, fires and/or seve-
re injuries.
−
Keep these Instructions for Use safe for future refe-
rence.
−
The term “battery pack” used in these Instructions for
Use equally relates to downtube-mounted battery
packs, rack-mounted battery packs and frame-integ-
rated battery packs.
−
Remove the battery pack (26) from the e-Bike before
working on it (e.g. when fitting, servicing or working
on the chain etc.), transporting it or placing it in sto-
rage.
→
There is a risk of injury if the e-Bike System is acti-
vated by mistake.
−
The push-assist may only be used when the e-Bike is
pushed.
→
There is a risk of injury if the wheels of the e-Bike
are not in contact with the ground when the push-
assist is used.
Use for the intended purpose
The display and control unit of the Brose e-Bike System
is intended solely for use in the latter. It is used to dis-
play information relevant for cycling and status, and to
control the drive unit.
Key to illustrations
The numbering of the components described relates to
the illustrations on the picture pages at the beginning of
these instructions (see page 4-5). All illustrations
are diagrammatical and hence may differ in some de-
tails from your e-Bike.
Item
Fig.
Explanation
1
2/4/5/7
Display unit
2
2
Mounting of display unit
3
2/3
Unlocking button of mounting
4
3
Fastening bolt
5
3
Position of USB interface
6
4
Menu button
7
4
Light button
8
4
On/Off button
9
5
Display of assist level
10
5
Display of push-assist
11
5
Display of cycling speed
12
5
Display of battery pack charge level
Item
Fig.
Explanation
13
5
Display of light mode
14
5
Display of multifunctional panel
15
6
Control unit
16
6
Cable routing of control unit
17
6
“Raise assist level” button
18
6
multifunctional panel button
19
6
“Lower assist level” button
20
7
Cover cap of USB interface
21
7
USB interface
22
8
Spoke magnet
23
8
Fastening bolt of spoke magnet
24
8
Speed sensor
Assembly
[Fig. 2] Inserting the display unit
−
Insert the display unit (1) with the guide groove on the
rear face into the guide opening of the mounting (2).
−
Slide the display unit (1) all the way down until you
hear it snap into place.
[Fig. 3] Removal preventer
The mounting (2) has an optional removal preventer.
−
Where applicable, screw the fastening bolt (4) lightly
from underneath into the mounting (2) once the dis-
play unit (1) is in place.
Removing the display unit
−
Deactivate the display unit (1) before removing it from
the mounting (2).
−
Undo the fastening bolt (4), where applicable.
−
Keep the unlocking button (3) pressed down and
push the display unit (1) upwards inside its guide
opening until it can be removed from the moun-
ting (2).
N.B.: An integrated memory ensures that your data (e.g.
clock time, kilometers per day, cycling time etc.) are
saved when the display unit (1) is removed.
Putting into service
Putting the display and control unit into service does
not require any further steps after assembly. The display
and control unit is ready to operate as soon as it has
been correctly inserted into the mounting (2).
N.B.: Full functioning is only possible when the speed
sensor (25) and the cables have been correctly fitted
and the battery pack (26) sufficiently charged.
Display and control unit
