30
X-VA-MT3809G-MT3810G-eng/541B182AAG/A/2022-10
Brooks Instrument
Installation Manual MT3809G & MT3810G
Section 2 Installation
7KHÀRDWLVFRQVWUXFWHGZLWKDQLQWHJUDOPDJQHWWKDWDFWLYDWHVDPDJQHWLF
VHQVRUWKDWLVSDUWRIWKHWUDQVPLWWHU7KLVVDPHÀRDWPDJQHWDOVRGULYHV
WKHPHFKDQLFDOSRLQWHU7KHÀRZUDWHLVVFDOHDEOHE\VHWWLQJLQGHSHQGHQW
high and low range parameters. The analog output (AO) transmitter
parameters, AO Hi-Range and AO Lo-Range span the 4-20 mA signal. For
H[DPSOHLIÀRZUDWHLVQRUPDOO\EHWZHHQDQGJSPWKH$2+L
Range parameter is set at 500 and the AO Lo-Range is set at 100.
f) Typically applications require only the use of the 2 wire loop analog
signal. In some applications where transmitters and actuators are widely
VHSDUDWHGHJWDQNIDUPVGHYLFHVDUHZLUHGLQDPXOWLGURSFRQ¿JXUDWLRQ
to save wiring costs. Each unit is given an individual HART address to
distinguish each unit during communications over a common wire pair.
,QWKLVFRQ¿JXUDWLRQWKHP$RXWSXWVLJQDOFDQQRWEHXVHG)ROORZ
the general HART foundation instructions for setting up a multi-drop
FRQ¿JXUDWLRQ
g) After installation and powering of the loop, the transmitter must be
zeroed, both electrically and mechanically. This operation will compensate
for any stray magnetic effects in the vicinity of the transmitter.
Important
7KH]HURDGMXVWLQJRIWKHSRLQWHULQÀXHQFHVWKHWUDQVPLWWHU
LQGLFDWLRQEXWQRWWKHRWKHUZD\DURXQG7KHUHIRUH¿UVWDGMXVWWKHSRLQWHU
DWWKH]HURÀRZSRVLWLRQWKHQWKHWUDQVPLWWHUPXVWEH]HURHG
L)ORZPXVWEHYHUL¿HGWREH]HURGXULQJWKHHQWLUH]HURLQJ
LL:LWKWKHÀRZDW]HURDQGWKHÀRDWDWWKH]HURÀRZSRVLWLRQDGMXVWWKH
PHFKDQLFDOLQGLFDWRUWRSRLQWWRWKHµ5¶UHIHUHQFHOLQHXVLQJWKH
adjustment screw on the face of the pointer, next to the hub.
)LJXUH0HFKDQLFDO,QGLFDWRU=HUR
8VLQJDÀDWEODGHVFUHZGULYHUZLWKDEODGHKROGWKHSRLQWHUDQG
turn the screw to align with the “R” on the scale.
It may take a few adjustments to get the pointer on the “R”.
