26
X-VA-MT3809G-MT3810G-eng/541B182AAG/A/2022-10
Brooks Instrument
Installation Manual MT3809G & MT3810G
Section 2 Installation
Directions to remove and reinstall the IS Housing Indicator Cover,
DGMXVW$ODUPVDQGWKH3RLQWHU
7REHJLQPDNHVXUHWKHÀRDWLVDWUHVWDQGWKHUHLVQ¶WÀRZJRLQJ
through the meter.
2. Using a T20 TORX tool loosen the 3 cover screws. Note, the screws
will stay attached to the cover.
3. Remove the cover from the housing. The gasket should still be
attached to the cover in the gasket groove. If not place the gasket into
the groove of the cover.
8VLQJDÀDWEODGHVFUHZGULYHUZLWKDEODGHKROGWKHUHGDODUP
pointer and turn the screw counterclockwise to loosen the pointer, slide it
to desired position on scale and tighten screw.
8VLQJDÀDWEODGHVFUHZGULYHUZLWKDEODGHKROGWKHSRLQWHU
and turn the screw to align with the “R” on the scale. It may take a few
adjustments to get the pointer on the “R”.
6. To replace the cover, place the cover against the housing and tighten
the 3 screws using a T20 TORX tool. Tighten to 45 in-lbs or 5.08 N-m to
keep a watertight seal.
How to Remove and Reinstall IS Housing Indicator Covers
Grounding
Screw
(accessed at
rear of meter)
