brondell S1200-EW, Руководство пользователя

Страница: 16 / 112

14
PRODUCT INSTALLATION (cont.)
REMOTE CONTROL INSTALLATION
1. Battery Installation
a. Separate the remote control from the magnetic dock.
b. Turn remote over and open the child-proof battery
compartment by popping off the battery cover with
a flat-head screwdriver or small coin. Insert the four
included CR2032 batteries “plus” side up and replace
battery cover.
c. To confirm the batteries are installed correctly, press the
Stop button and you should see the “Wide Spray” LED
light turn on for a few seconds (NOTE: the 2 other LED
lights may or may not turn on at this time depending on
the current settings).
2. Mount Remote (optional)
a. Identify a location in the bathroom for the remote
control that is visible and reachable from the toilet.
b. Depending on the wall type, you can install using
the supplied screws and anchor mounts or use the
provided double stick tape on the back of the remote
wall mount.
Make sure the remote mount is fully secure with either
method so that it does not fall and damage the remote
control.
c. Place the remote control into the mount as shown.
Step 2c
DANGER – Important Battery Information:
1. Remote contains “coin-style” batteries – keep away from children. If swallowed, seek
medical attention immediately.
2. Ingestion of batteries may cause severe injury or death in just 2 hours.
3. Use only CR2032 batteries. Do not mix new and old batteries together.
4. Double-check the + and – direction.
5. Take care when opening the battery compartment to replace the batteries - the
batteries are spring-loaded.
6. Dispose of old batteries carefully.
Step 1b
For California Residents: CR2032 batteries contain Perchlorate Material - special handling
may apply. Visit http://www.dtsc.ca.gov/hazardouswaste/perchlorate for more information.