23
USING THE SWASH 1200/1400 (cont.)
User Memory Setting
The Swash User 1 and User 2 memory function allows you to program your preferred wash
settings for a Front and Rear wash cycle for two users. These settings include: Water
Temperature Level, Spray Width Level, Water Pressure Level, Nozzle Position, and Nozzle
Oscillation*. Follow the steps below to program and use the Memory Function.
*only available on the Swash 1400 model
Programming User 1 or User 2 Memory Function
1. Sit on the seat. The seat will give an audible response letting you know that the seat sensor
has been engaged (unless “Silent Mode” has been set to On). At the same time, a small
amount of water will flush over the nozzle, performing an automatic self-cleaning cycle.
2. To program Front nozzle settings, press and release the Front button. To program Rear
nozzle settings, press and release the Rear button. A wash cycle will commence.
a. While the wash is operating, set your desired Water Temperature Level, Spray Width
Setting, Water Pressure Level, Nozzle Position, and Oscillation option.*
b. Let the wash cycle run the full two minutes or press the Stop button at any time.
3. If desired, initiate another wash cycle using the opposite nozzle.
a. While the wash is operating, set your desired Water Temperature Level, Spray Width
Setting, Water Pressure Level, Nozzle Position, and Oscillation option.*
b. Let the wash cycle run the full two minutes or press the Stop button at any time.
4. Press and hold the User 1 or User 2 button on the remote for five (5) seconds to save the
programming. You should hear an audible beep when the settings are programed.
Continued on next page...
Содержание S1200-EW
Страница 110: ...108 NOTES NOTAS REMARQUES ...
Страница 111: ...109 NOTES NOTAS REMARQUES ...
Страница 112: ......