Comfort-Tilt
27
WARNING:
After any adjustments, repair or service, before use, make sure all attaching hardware is
tightened securely. Otherwise injury or damage may result.
CAUTION:
DO NOT over-tighten hardware as this could cause damage to the frame.
Note: Please include the model number and serial number of the wheelchair whenever you are
ordering parts. These can be found on a sticker that is attached to the base on the bottom of the
chair.
NOTE: Only a person with training on the BRODA chair should attempt to do any repairs or
maintenance on the wheelchair. Certain repairs may require a BRODA representative to
personally attend to the repair. If you are unsure as to what is required, call BRODA customer
service at 1-800-668-0637.
5.3
Cables and Cable Handles
Maintaining the Cables and Cable Handles
The cables and cable handles do not require any maintenance. Both replacement pieces are
shipped together fully assembled.
Removing and Installing the Cables and Cable Handles
The cable is used in conjunction with a cable handle and an actuator to control the function of the
gas cylinder. The cable is held in place on the handle end by a cable housing retaining clip. On
the actuator end the cable hooks into the lever that depresses the control pin on the cylinder and
the cable housing clip into the actuator housing.
1. Loosen the nut on the bottom of the cylinder. Unclip the cable from the actuator lever on
the cylinder.
Cable
Cable Handle