Brocade Communications Systems NetIron CER 2024C, Руководство по оборудованию

Страница: 83 / 110

Brocade NetIron CES and Brocade NetIron CER Hardware Guide 71
53-0000080-03
Fiber optic module replacement
5
CAUTION
For safety reasons, the ESD wrist strap should contain a series 1 Meg ohm resistor.
•
The protective covering that you removed from the fiber optic module when you initially
installed the module.
Follow the steps given below to remove a fiber optic module from a Gigabit Ethernet or 10-Gigabit
Ethernet port.
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a metal surface
(such as an equipment rack).
2. Disconnect the fiber cable connector from the port connector.
3. Insert the protective covering into the port connectors.
4. Pull the fiber optic module out of the port by pulling the bail latch forward, away from the front
panel of the module. This unlocks the module from the front panel.
NOTE
The bail latch may be attached to either the top or the bottom of the mini-GBIC.
5. Grasping the bail latch, pull the fiber optic module out of the port.
6. Store the fiber optic module in a safe, static-free place or in an anti-static bag.
7. Install a new fiber optic module in the port. For information about performing this task, refer to
“Installing a new fiber optic module” on page 71.
Installing a new fiber optic module
You must install a fiber optic module (SFP, SFP+, or XFP transceiver) in each Gigabit Ethernet and
10-Gigabit Ethernet fiber port you want to use.
You can install a new fiber optic module in a port while the device is powered on and running.
Before installing one of these modules into the port, obtain an ESD wrist strap with a plug for
connection to a metal surface.
1 Bail latch